Title: Alloy Die Casting
Description: Alloy die casting has always been seen in the life of clothing,
clothing and housing.
Alloy Die Casting
Aluminum alloy Die Casting Machine and CNC ,Power coating
Electroplating ,Power Coating
Aluminum alloy Die Casting Machine and CNC
Material certificate, QC reports, Surface treatment inspection
15~20days lead time. By DHL/TNT/FedEx express, air freight etc.
Delivery & Service
Timely delivery each time. Provide reliable service and responsible
for eachcustomer with each product. Our target is to satisfy every
customer with the best service.
Die casting magnesium alloy
(1) characteristics of magnesium and magnesium alloys and their
application prospects in economic and social development
Magnesium is a typical light metal. Magnesium and magnesium alloys
have the advantages of small density (only 1.78, 1. 82g/mm3,
aluminum 2/, 1/4), which have higher strength and specific
stiffness, better dimensional stability, good resistance to
corrosion and electromagnetic radiation, low thermal capacity and
solidification latent heat, good casting process properties, good
cutting properties and renewable properties, as well as suction.
Special properties such as hydrogen, vibration absorption,
luminescence and artificial lattice.
The shortcomings of magnesium and magnesium alloys: one is easy to
oxidize and combustible. In the process of melting, casting, heat
treatment, cutting and other processes, it is easy to burn and
explode in the state of powder. But as long as strict compliance
with operating regulations, careful operation, and qualified
protection facilities and measures, a conditional ring is added to
03% broken (Be) and burning explosion in the alloy. The fry can
also be avoided; two is easy to corrode. From the electrochemical
point of view, magnesium is more prone to electrochemical corrosion
than many other metals, and the oxide film formed on its surface is
loose, so its corrosion resistance is low.
Therefore, the surface oxidation and coating protection for
magnesium alloy castings are required, and the magnesium alloy
parts are assembled with other material parts. The electrochemical
corrosion should be avoided in direct contact with aluminum alloy
(except aluminum alloy aluminum alloy), copper alloy, mirror steel
and other parts.
Plastic, rubber or paint should be used as gaskets to be separated.
1. the surface effect is good, it can't be numb.
The engineering says that there are 4 more thimble positions in the
mold. Is there any gravure inside the product? It is to ensure that
the surface is done better.
2. the rotary nut and the nut will be scratching, and the elastic
function will be stuck. Can it improve?
Yes, we will proofread it again and send it to our guest.
3.Can there be only 500 for 6. batches? There will be a slow mass
production in the back.
Because of the high cost of the model, first small test production
can be understood, I will apply to the leadership of the company,
but the following batch production should be set according to our
MOQ2000, because this product is a process, small amount of bad
operation, our workers are also a piece of wages, often change the
process is not good for the workers, I hope you can understand,
thanks. Thank you.
4. this product is smooth and large, requiring no pitting and
scratching on the surface. Is that possible?
This is a little difficult, because the products of the alloy will
have this kind of unavoidable phenomenon. It needs a standard
sample to make the goods. With our experience, we suggest that you
can spray sand on the surface of your company. The products we've
done before are all sandblasting. I can send you a sample to show
you the effect. It is very good.
5.ADC12 be welded with aluminum profiles? Is it strong enough to
We have tried that ADC12 can be dumb argon welded with aluminum
profiles, but there will be pores at the weld, because of the
density of the reason, bearing a large force will also fracture. So
you need to do your tension test.