Country/Region china
Company Guangzhou Fcard Electronics Co.,Ltd
Categories Access Control Power Supply
Update 2017-05-03 10:38:24
ICP License Issued by the Chinese Ministry
The power supply is absolutely high-grade electronic components,
the use of international advanced manufacturing process technology
processes,quality must be reliable.
Features:
1.AC input:220V/50HZ, DC Output:regulated 12V, the standard output current 3A/5A;
2.The direct control of the electronic locks, access control can reduce the load, interference, save project wiring, reducing failure risks;
3.Set NO/NC (normally open/ normally closed)interface,can control various types of electronic locks;
4.Set time delay circuit,lock time can be adjusted in the 0-15 seconds;
5.Automatic protection function,causing a short circuit when the circuit accident occurs, the power supply will be temporarily disconnected or burning fuse;
6.Remote control,remote control module can be inserted using the remote control to open the door remotely.(Remote from Leaving Wide ground without interference of 80 meters)
Dimensions:205mm high x 165mm wide x 74mm deep(large box)
180mm long x 80mm wide x 60mm high (small box)
Wiring Diagram:
Cabling Instructions:
1-2: Regulated output DC12V,1 positive, 2 negative
2-3: Open button connection terminal can be connected to switch output(relay output).
3-4: Low-frequency signal output, connected to access controller signal lines.
4-5: NO -GND, normally open no power output, trigger output DC12V-17V, 4 positive 5 negative.
5-6: NC -GND, normally closed output DC12V-17V, triggering power outages, 6 are positive, 5 negative.
6-7: The high-frequency signal output, on the positive lock.
7-8: Connect the host building intercom lock signal input interface, 7L +, 8 of L - + 8, - 9 for the building intercom unlock signal, L +, L - input port, or as high as + 8 radio frequency input, - 9 is low frequency input(this only C plate)
![]() |
FC-803 Access Control Power Supply Images |